Euro-Enduro
Two Hours of Non-Stop Racing Intensity
December 28, 2019
Two Hours of Non-Stop Racing Intensity
December 28, 2019
Other Trucker 500
500 Laps of Non-Stop Racing Intensity
May 30, 2020
Team Event
Teams of 3 or 4 members/drivers can participate in a 500 lap race
Event Length -
Euro-Enduro - Two hours of Racing One Truck for the entire race - Multiple Drivers
Other Trucker - 500 Laps of Racing One Truck for the entire race - Multiple Drivers
Teams - Must consist of 3 or 4 members. Each Team Member MUST drive for a full battery discharge stint during the race. Driver change required each time a team changes battery.
Entry Fee - $15 Per Team Member/Driver Minimum of 3 members per team
Schedule
10 am - Track Opens - Truck Prep and Practice
12:30 pm - Track Closed
12:45 pm - Teams Meeting
1:00 pm - Qualifying - Best time in a single five lap qualifier
2:00 pm - Racing
4:00 pm - Finish
Rules - Yes there are rules!!!!!
Truck
Ride Height = 8 mm minimum
Weight Range = 1740g to 1810 g
Gear Ratio = Kit Stock gear only
The truck must use only OEM components (Extra Batteries can be purchased separately and MUST be approved by Race Management prior to the start of the race.)
Truck Mods Permitted
Shock lube may be applied to plunger
Shock position and overall length assembled
Ride Height
Battery Connector = Type and Position
Tire sidewall glueing
This is a pure box stock class open to any skill level hobbyist.
- Legal kits: Item 58632 RC Team Hahn Racing MAN TGS (TT-01 type E chassis), item 58661 Byggyra Fat Fox or Item 58642 RC Team Reinert Racing MAN TGS (TT-01 type E chassis)
- The kit must be built EXACTLY per the instruction manual. Battery connectors may be changed to racer's preference. Tire sidewalls ONLY may be glued. No glue permitted on treads. Dampers and differentials may lubricated to racer's preference.
- The ONLY Hop-Op Option permitted is Ball Bearings. (ANY BRAND of bearing)
- Must use stock pinion and spur gear.
- The kit Tamiya TBLE-02S ESC and kit supplied motor (item 54358 RS-540 TorqueTuned Motor) must be used. Motor Bullet connectors may not be removed. NOTE: ESC & Motor wires may not be shortened!
- All body parts must be used.
- All screws in the kit must be used. I.E. You may not omit screws to change the handling of the truck.
- Body may be painted in any scheme.
- Adding FOAM material to the kit foam bumper is permitted.
- Must use kit tires and wheels. Kit tires may be glued onto wheel.
- Any grease or lube may be used to lubricate gears or moving parts.
- Batteries: 2S Lipo or 6S Ni-Mh (round cells) with a capacity of 4200mah or less must be used.
Format
This is a team event. Teams may consist of 3 to 5 members. Race will be run 500 laps.
Drivers
At least 3 drivers from a team must drive and marshal. Any driver that fails to marshal immediately and for the full term of the next driver stint (minimum of 10 minutes) may lose as many as all laps completed from their previous stint. Driver change required whenever a battery change occurs. Each team member MUST drive at least one stint.
Repairs and Battery Changes
All pit stops and repairs MUST be done in a pit area away from the track. Drivers may leave the stand to assist with repairs. No battery changes may occur during repairs. Driver on the stand must return to the stand to complete the battery/driving stint.
Pits
Pit stops and race re-entry must must be done only in the locations designated by race director.